VMware SD-WAN Design and Deploy 2021 Exam 5V0-42.21 Dumps Questions

VMware SD-WAN Design and Deploy 2021 certification requires to take and pass 5V0-42.21 exam to test your knowledge, skills, and abilities to deploy a VeloCloud SD-WAN. New 5V0-42.21 dumps questions are based on the actual 5V0-42.21 exam objectives. The top experts collected 52 Q&As covering VMware SD-WAN Design and Deploy Skills to ensure that you can pass VMware certification 5V0-42.21 exam successfully.

Test VMware Certification 5V0-42.21 Free Dumps First

1. Which statement describes a characteristic of VMware SU-WAN Edge (VCL) clustering?

2. An Enterprise customer just acquired a new company, and the Network Enterprise administrator was tasked to integrate over 20 new branches into their existing SD-WAN network. However, these branches have overlapping IPs with the existing branches subnets.

3. Due to very strict security policies an enterprise customer is looking for an on-premises deployment of the VMware SD-WAN Orchestrator and Controllers. Customer data is not expected to flow through this Controller, however it is desirable that management plane traffic towards the Orchestrator coming from VMware SD-WAN Edges can take the overlay tunnels through this controls.

What are some of the needed steps to achieve the requirements above?

4. What is considered a typical VMware SD-WAN use case?

5. Company a has recently acquired Company B, which has two remote office. Company A is using VMware hosted Cloud Gateways, and Company B is using a VMware SD-WAN with a Hub-Spoke topology.

Which VEware Cloud VPN solution an administrator configure to establish connectivity between the offices of Company A and Company B?

6. Refer to the exhibit.

An MSP is designing a solution for a merger of Customer A and Customer B to Customer A’s enterprise. Due to overlapping IP addresses and security requirements, the segments with the same names between Customer A and Customer A cannot be merged.

Based on the graphic and the requirements, how many new segments need to be configured in the VMware SD-WAN Orchestrator?

7. A VMware SD-WAN customer has a requirement to enable single sign-on (SSO) authentication to their existing provider (idp) for access to their Orchestrator account.

Which authentication protocol is supported?

8. Which form factor can a customer use to deploy VMware SD WAN Edge?

9. A network architect is designing a VMware SD-WAN architect for customer using VMware hosted VCO and VCGs, white VCEs will be deployed at the customer’s branches and data centers. The network architect would like to achieve control plane redundancy.

Which action, if any, should be taken to meet this goal?

10. A customer has deployed VMware SD_WAN solution An administrator asked to imported additional security for traffic going to internet without investigating in new hardware solutions.

11. A MSP partner needs to setup a Partner Gateway and configure the Handoff Interlace.

Which are the valid configuration options for the Tag type?

12. Which characteristic of Software Defined Networks (SDN) is also true for VMware SD-WAN

13. A service provider assigns two Partner Gateways to a VMware SD-WAN Edge.

Which description is correct about default route.

14. Which port is used for the high availability connection between the two Edges on a pair of Edge 510s?

15. A service provider needs to ensure that the NOC is notified proactively in the event that an Edge interface loses connectivity to its WAN provider.

Which three methods are available for generating these alerts? (Choose three.)


 

VMware Certified Associate 6 – Data Center Virtualization Exam 1V0-621 Dumps
Advanced Design VMware vSphere 7.x 3V0-21.21 Dumps Questions Updated

Add a Comment

Your email address will not be published. Required fields are marked *