Use Huawei HCIA-5G-RNP&RNO V2.0 H35-580_V2.0-ENU Dumps (V8.02) to Boost Your Confidence – We have H35-580-V2.0-ENU Free Dumps (Part 1, Q1-Q40)

1. In the continuous CA scenario in the protocol frequency band, what is the maximum center frequency band interval between carrier 1 (60MHz bandwidth) and carrier 2 (100MHz bandwidth) in the n41 frequency band?

2. Which of the following manufacturers was the first to complete the SA functional test of the domestic IMT-2020 5G Promotion Group?

3. Which piece of information will not be referenced by the automatic deletion of neighbor relations feature?

4. The redirection process has lower service interruption delay than the switching process.

5. The scheduling priority of retransmitted data is higher than that of initially transmitted data.

6. Which of the following in the terminal capability report indicates that the terminal supports antennas?

7. The terminal can send a power control command to the base station to control the transmit power of the PDSCH.

8. Imbalanced terminal receiving antennas will affect RANK performance. Generally, within what range can the average RSRP difference of different antennas be considered balanced?

9. The initial TA (time advance) adjustment of the terminal is obtained through which of the following messages?

10. The distribution link of the smart grid will use both wireless and wired networks.

11. As long as the SSB frequency or SCS between the serving cell and the neighboring cell is different, the terminal's measurement of the neighboring cell is an inter-frequency measurement.

12. For SA networking, voice solutions include VONR and CSFB

13. For the N78 frequency band, which of the following time slot ratios (downlink, uplink) can support the transmission of SSB beams?

14. For a 60KHZ SCS configuration, how many time slots are included in a radio frame?

15. For a 100MHz cell, when the downlink uses type 0 allocation, what is the minimum resource allocated in the frequency domain?

16. How much data does the SSB that occupies 20 RB resources carry?

17. Which parameter indicator will not be referenced in the SCell deactivation management of carrier aggregation?

18. When testing the downlink peak value of an NR network, which of the following should the PDSCH DMRS type be configured to?

19. If the MeasAndMobParametersMRDC of the terminal MR-DC capability contains the independentGapConfig information element, which GAP configuration is recommended for NR inter-frequency measurement?

20. In the existing network, we recommend that all cells use the configuration parameters under the peak rate scenario to improve user experience.

21. During downlink data transmission, if the terminal suddenly fails to report CQI, what will happen?

22. In downlink detection, what is the PDCCH BLER synchronization threshold Qin?

23. Which of the following factors is not involved in calculating the number of RBs for a user in downlink scheduling?

24. During downlink scheduling, which of the following services has the highest scheduling priority?

25. During the downlink MCS adjustment process, the base station makes the adjustment based on which of the following measurements?

26. During the same-frequency cell reselection process, if you want to make it easier for the terminal to reselect from the serving cell to a specific neighboring cell, how can you modify the parameters?

27. Among the A3 event parameters for intra-frequency handover, which of the following parameters cannot be configured individually based on QCI?

28. When using Probe to test the NSA network, it is found that the MAC layer rate of LTE uplink is 20Mbps, but the PDCP layer rate is 0. Which of the following understandings is correct?

29. In the uplink power control process, the power control of SRS is related to the power control of which channel?

30. During uplink scheduling, what is the fixed value of the “logical channel guaranteed rate” for each non-GBR logical channel?

31. During the handover preparation process, the source cell determines the target cell for handover based on which of the following parameters?

32. Which of the following parameters does not need to be configured in the command to configure the 5G external cell?

33. In each TTI scheduling, the scheduling priority of the control plane information is absolutely higher than the scheduling of the data plane.

34. In the drive test tool, which of the following indicators cannot be monitored?

35. In the process of connecting A from in-vehicle information services to intelligent transportation, the intelligentization of the network and the intelligentization of the infrastructure need to work together.

36. In an inter-frequency handover scenario based on frequency priority, which of the following event measurement reports is used to trigger inter-frequency measurements?

37. In high frequency scenarios, what is the maximum subcarrier spacing that can be used for all channels and signals?

38. In low-frequency scenarios, how does the UE obtain the beam ID of the current SSB?

39. In the window size, the larger the window, the stronger the resistance to delay

40. In the UE access anchor point policy, if the "cell prohibited" state is set to "prohibited", the UE cannot occupy the resources of this cell.