Updated DELL EMC D-VXB-DY-A-24 Exam Dumps (V9.02) – Easy Learning Way to Succeed in Dell VxBlock Deploy Certification Exam

1. What is the responsibility of the Implementation Specialist during the deployment cycle?

2. A System Engineer is validating system cabling for a VxBlock 1000. They find that some ports on Fabric Interconnects 1A are not connected.

Which connections are missing?

3. What is needed to provide network isolation between vSwitch port groups?

4. What is used to collect VxBlock component information during an RCM Assessment?

5. A VxBlock 1000 is running VMware vSphere 6.7. To support an audit, a customer engineer is trying to map the networking components in the VxBlock to a traditional datacenter architecture.

Which component should the engineer map to the access switch?

6. Which file system architecture is used on Isilon storage to deliver increased performance for file-based data applications and workflows?

7. What is the purpose of the Knowledge Transfer process with the customer?

8. A VxBlock 1000 system engineer is powering on Advanced Management Pod components.

If AMP-VX is used, what is the first component to be powered on?

9. Which NSX component communicates with the VTEP?

10. A customer is using Cisco UCS 6332-16UP 40-Port Fl. They have 16 ports dedicated for FC traffic. The customer needs to increase the number of FC ports.

What is a consideration?

11. Based on the RCM Upgrade Process RACI, who is responsible and accountable for the pre-upgrade questionnaire used during the Initiation Phase?

12. A customer engineer is unable to securely connect to vCenter using their laptop. Both the vCenter and the customer laptop are behind a firewall. The network security team requests that the customer engineer provide source and destination port numbers to establish the needed connection.

What ranges of source and destination port numbers are valid?

13. Who is responsible for raising the Internal Assessment (IA) during an RCM upgrade?

14. Refer to the exhibit.

A cable with the following label was connected to the wrong equipment type:

* M91A-01:01 U61A-01:09

Based on the exhibit, what is the target equipment type?

15. DRAG DROP

In the Enhanced Knowledge Transfer Phase, what is the correct sequence of steps in the Finalize Project Deliverables?

16. DRAG DROP

Based on the Dell EMC RCM Workbook upgrade plan, in what sequence should VxBlock components be upgraded?

17. A VxBlock 1000 system is being deployed at a customer site. The system is equipped with a Nexus 93180YC aggregation switch to support routing features. A Juniper switch is used at the customer site as the core switch. The customer intends to run a dynamic routing protocol between the Nexus and Juniper switches.

Which routing protocol is recommended?

18. How many VMs are required by VxBlock Central to support an RCM upgrade?

19. Which logical entity in ACI allows for logical separation and reuse of IP address space within an ACI fabric?

20. According to the Test Plan guidelines, how should you validate redundancy capabilities of the network during a system failure?

21. What is the recommended source to download a Test Plan for a specific VxBlock model?

22. DRAG DROP

Match each Dell Unity system DAE capacity to the corresponding maximum number of supported 2.5 inch drives.

23. What is the main advantage of separating the network control plane from the data plane in a Software Defined Network?

24. DRAG DROP

Match each role to its responsibility.

25. Which document contains all software baseline information post-RCM upgrade?