Specialist – Systems Administrator PowerProtect DD Exam DES-DD33 Dumps Questions

1. An administrator has retained snapshots for a single MTree and is trying to create a new one. An error message is received.

What is the reason for the failure?

2. Which PowerProtect DD procedure uses the DoD/NIST standards to provide data security?

3. Which PowerProtect DD technology provides fast and efficient deduplication while minimizing disk access?

4. DRAG DROP

What are the steps to configure the Retention Lock Compliance?

5. An organization uses tape libraries in their current backup infrastructure. They have purchased a PowerProtect DD system and plan to use VTL to move from physical tape.

What is a consideration when configuring the tape size?

6. A PowerProtect DD appliance has been installed at a company’s location for several months and has reached a steady state.

As a best practice, at what percentage of disk utilization should action be taken?

7. What is a requirement to use the PowerProtect DD HA feature?

8. What is the maximum capacity that a cloud unit can have with DD9900?

9. A PowerProtect DD backup administrator wants to delegate some Operations to their Monitoring and Control team. The administrator wants to add a user to the Monitoring and Control team with limited access to only check the health of the PowerProtect DD appliance.

Which role must be applied to the new user?

10. A backup administrator wants to verify that quotas have been enabled on a PowerProtect DD appliance.

Which command is used to verify that quotas are being enforced?

11. An administrator is migrating their old cloud tier-enabled Data Domain to a new PowerProtect DD appliance with cloud tier. During migration, the administrator recognizes that file system cleaning on the source system is not possible.

What is the most likely cause of this behavior?

12. A backup administrator is tasked with monitoring PowerProtect DD capacity metrics. The administrator is backing up 2 of data daily with a reduction rate at 5x. After data reduction, subsequent full backups compress down to 100 GB.

The initial backup requires 400 GB with a 10 percent increase in the data each day. Each incremental backup is 200 GB. After data reduction, each incremental backup is 20 GB.

What is the weekly burn rate (GB) after six daily incremental backups and one weekly backup?

13. An administrator is scaling Cloud Tier for a DD9400 by adding a second cloud unit.

What is the required amount of metadata storage ()?

14. Which protocol is used for communications between a PowerProtect DD appliance and cloud tier to Dell EMC ECS?

15. DRAG DROP

What is the correct sequence of operations used by the PowerProtect DD DIA in the end-to-end verification process?