Prepare Thoroughly with the Most Updated NSE7_OTS-7.2 Dumps (V10.02) for Excellent Marks

1. What are two benefits of a Nozomi integration with FortiNAC? (Choose two.)

2. Which three criteria can a FortiGate device use to look for a matching firewall policy to process traffic? (Choose three.)

3. Refer to the exhibit and analyze the output.

Which statement about the output is true?

4. Which three Fortinet products can be used for device identification in an OT industrial control system (ICS)? (Choose three.)

5. Refer to the exhibit

In the topology shown in the exhibit, both PLCs can communicate directly with each other, without going through the firewall.

Which statement about the topology is true?

6. In a wireless network integration, how does FortiNAC obtain connecting MAC address information?

7. Which three common breach points can be found in a typical OT environment? (Choose three.)

8. Refer to the exhibit.

You are navigating through FortiSIEM in an OT network.

How do you view information presented in the exhibit and what does the FortiGate device security status tell you?

9. An OT network administrator is trying to implement active authentication.

Which two methods should the administrator use to achieve this? (Choose two.)

10. Refer to the exhibit.

An OT administrator ran a report to identify device inventory in an OT network.

Based on the report results, which report was run?

11. An OT administrator deployed many devices to secure the OT network. However, the SOC team is reporting that there are too many alerts, and that many of the alerts are false positive. The OT administrator would like to find a solution that eliminates repetitive tasks, improves efficiency, saves time, and saves resources.

Which products should the administrator deploy to address these issues and automate most of the manual tasks done by the SOC team?

12. Refer to the exhibit.

You need to configure VPN user access for supervisors at the breach and HQ sites using the same soft FortiToken. Each site has a FortiGate VPN gateway.

What must you do to achieve this objective?

13. An OT supervisor has configured LDAP and FSSO for the authentication. The goal is that all the users be authenticated against passive authentication first and, if passive authentication is not successful, then users should be challenged with active authentication.

What should the OT supervisor do to achieve this on FortiGate?

14. An OT network architect needs to secure control area zones with a single network access policy to provision devices to any number of different networks.

On which device can this be accomplished?

15. Refer to the exhibit.

Based on the topology designed by the OT architect, which two statements about implementing OT security are true? (Choose two.)

16. Which three methods of communication are used by FortiNAC to gather visibility information? (Choose three.)

17. An OT architect has deployed a Layer 2 switch in the OT network at Level 1 the Purdue model-process control. The purpose of the Layer 2 switch is to segment traffic between PLC1 and PLC2 with two VLANs. All the traffic between PLC1 and PLC2 must first flow through the Layer 2 switch and then through the FortiGate device in the Level 2 supervisory control network.

What statement about the traffic between PLC1 and PLC2 is true?

18. An OT administrator is defining an incident notification policy using FortiSIEM and would like to configure the system with a notification policy. If an incident occurs, the administrator would like to be able to intervene and block an IP address or disable a user in Active Directory from FortiSIEM.

Which step must the administrator take to achieve this task?

19. When you create a user or host profile, which three criteria can you use? (Choose three.)

20. Refer to the exhibit, which shows a non-protected OT environment.

An administrator needs to implement proper protection on the OT network.

Which three steps should an administrator take to protect the OT network? (Choose three.)