New NSE7_EFW-7.0 Exam Dumps To Be The Proper Fortinet NSE 7 – Enterprise Firewall 7.0 Exam Preparation

Come here to choose the proper Fortinet NSE 7 – Enterprise Firewall 7.0 exam preparation to pass the NSE7_EFW-7.0 exam. DumpsBase has updated the NSE7_EFW-7.0 exam dumps with the newest questions and answers to ensure your success. DumpsBase makes the Fortinet NSE 7 – Enterprise Firewall 7.0 NSE7_EFW-7.0 exam preparation a lot easier for you personally to pass the Fortinet NSE7_EFW-7.0 exam on the 1st attempt.

Fortinet NSE 7 – Enterprise Firewall 7.0 NSE7_EFW-7.0 Free Demo Dumps Below

1. Refer to the exhibit, which contains partial output from an IKE real-time debug.

Which two statements about this debug output are correct? (Choose two.)

2. View the exhibit, which contains the partial output of an IKE real-time debug, and then answer the question below.

The administrator does not have access to the remote gateway.

Based on the debug output, what configuration changes can the administrator make to the local gateway to resolve the phase 1 negotiation error?

3. An administrator has created a VPN community within VPN Manager on FortiManager. They also added gateways to the VPN community and are now trying to create firewall policies to permit traffic over the tunnel; however, the VPN interfaces are not listed as available options.

What step must the administrator take to resolve this issue?

4. Examine the output of the 'diagnose debug rating' command shown in the exhibit; then answer the question below.

Which statement are true regarding the output in the exhibit? (Choose two.)

5. How does FortiManager handle FortiGuard requests from FortiGate devices, when it is configured as a local FDS?

6. View these partial outputs from two routing debug commands:

Which outbound interface will FortiGate use to route web traffic from internal users to the Internet?

7. Refer to the exhibit, which shows the output of a diagnose command.

What can be concluded about the debug output in this scenario?

8. An administrator has configured two FortiGate devices for an HA cluster. While testing the HA failover, the administrator noticed that some of the switches in the network continue to send traffic to the former primary unit. The administrator decides to enable the setting link-failed-signal to fix the problem.

Which statement is correct regarding this command?

9. View the central management configuration shown in the exhibit, and then answer the question below.

Which server will FortiGate choose for antivirus and IPS updates if 10.0.1.243 is experiencing an outage?

10. Exhibits:

Refer to the exhibits, which contain the network topology and BGP configuration for a hub.

An administrator is trying to configure ADVPN with a hub-spoke VPN setup using iBGP. All the VPNs are up and connected to the hub. The hub is receiving route information from both spokes over iBGP; however, the spokes are not receiving route information from each other.

What change must the administrator make to the hub BGP configuration so that the routes learned by one spoke are forwarded to the other spokes?

11. Refer to the exhibit, which contains the output of diagnose sys session list.

If the HA ID for the primary unit is zero (0), which statement about the output is true?

12. View the exhibit, which contains the output of get sys ha status, and then answer the question below.

Which statements are correct regarding the output? (Choose two.)

13. Which statement about protocol options is true?

14. An administrator has decreased all the TCP session timers to optimize the FortiGate memory usage. However, after the changes, one network application started to have problems. During the troubleshooting, the administrator noticed that the FortiGate deletes the sessions after the clients send the SYN packets, and before the arrival of the SYN/ACKs. When the SYN/ACK packets arrive to the FortiGate, the unit has already deleted the respective sessions.

Which TCP session timer must be increased to fix this problem?

15. A FortiGate is configured as an explicit web proxy. Clients using this web proxy are reposting DNS errors when accessing any website.

The administrator executes the following debug commands and observes that the n-dns-timeout counter is increasing:

What should the administrator check to fix the problem?

16. Refer to the exhibit, which contains a screenshot of some phase 1 settings.

The VPN is not up. To diagnose the issue, the administrator enters the following CLI commands to an SSH session on FortiGate: diagnose vpn ike log-filter dst-addr4 10.0.10.1 diagnose debug application ike -1

However, the IKE real-time debug does not show any output.

Why?

17. Which two tasks are automated using the Install Wizard on FortiManager? (Choose two.)

18. Refer to the exhibit, which shows the output of a BGP debug command.

Which statement explains why the state of the 10.200.3.1 peer is Connect?

19. View the global IPS configuration, and then answer the question below.

Which of the following statements is true regarding this configuration?

20. The CLI command set intelligent-mode <enable | disable> controls the IPS engine’s adaptive scanning behavior.

Which of the following statements describes IPS adaptive scanning?

21. In which two states is a given session categorized as ephemeral? (Choose two.)

22. View the exhibit, which contains the output of diagnose sys session stat, and then answer the question below.

Which statements are correct regarding the output shown? (Choose two.)

23. Which real time debug should an administrator enable to troubleshoot RADIUS authentication problems?

24. Four FortiGate devices configured for OSPF connected to the same broadcast domain. The first unit is elected as the designated router. The second unit is elected as the backup designated router Under normal operation, how many OSPF full adjacencies are formed to each of the other two units?

25. Refer to the exhibit, which contains the partial output of a diagnose command.

Based on the output, which two statements are correct? (Choose two.)

26. View the exhibit, which contains an entry in the session table, and then answer the question below.

Which one of the following statements is true regarding FortiGate’s inspection of this session?

27. An administrator added the following Ipsec VPN to a FortiGate configuration:

configvpn ipsec phasel -interface

edit "RemoteSite"

set type dynamic

set interface "portl"

set mode main

set psksecret ENC LCVkCiK2E2PhVUzZe

next

end

config vpn ipsec phase2-interface

edit "RemoteSite"

set phasel name "RemoteSite"

set proposal 3des-sha256

next

end

However, the phase 1 negotiation is failing. The administrator executed the IKF real time debug while attempting the Ipsec connection.

The output is shown in the exhibit.

What is causing the IPsec problem in the phase 1 ?

28. View the exhibit, which contains a screenshot of some phase-1 settings, and then answer the question below.

The VPN is up, and DPD packets are being exchanged between both IPsec gateways; however, traffic cannot pass through the tunnel.

To diagnose, the administrator enters these CLI commands:

However, the IKE real time debug does not show any output.

Why?

29. Refer to the exhibit, which contains partial output from an IKE real-time debug.

Which two statements about this debug output are correct? (Choose two.)

30. Examine the output of the ‘get router info ospf interface’ command shown in the exhibit; then answer the question below.

Which statements are true regarding the above output? (Choose two.)

31. Examine the output from the 'diagnose debug authd fsso list' command; then answer the question below.

# diagnose debug authd fsso list ―FSSO logons-IP: 192.168.3.1 User: STUDENT Groups: TRAININGAD/USERS Workstation: INTERNAL2. TRAINING. LAB The IP address 192.168.3.1 is NOT the one used by the workstation INTERNAL2. TRAINING. LAB.

What should the administrator check?

32. Refer to the exhibits, which show the configuration on FortiGate and partial session information for internet traffic from a user on the internal network.

If the priority on route ID 2 were changed from 10 to 0, what would happen to traffic matching that user session?

33. Which two conditions would prevent a static route from being added to the routing table? (Choose two.)

34. Refer to the exhibit, which contains partial outputs from two routing debug commands.

Why is the port2 default route not in the second command's output?

35. View the exhibit, which contains the output of a web diagnose command, and then answer the question below.

Which one of the following statements explains why the cache statistics are all zeros?

36. What is the diagnose test application ipsmenitor 5 command used for?

37. View the exhibit, which contains the output of a real-time debug, Which statement about this output is true?

Which of the following statements is true regarding this output?

38. What does the dirty flag mean in a FortiGate session configured for NGFW policy mode?

39. View the following FortiGate configuration.

All traffic to the Internet currently egresses from port1.

The exhibit shows partial session information for Internet traffic from a user on the internal network:

If the priority on route ID 1 were changed from 5 to 20, what would happen to traffic matching that user’s session?

40. Refer to the exhibit, which shows a FortiGate configuration.

An administrator is troubleshooting a web filter issue on FortiGate. The administrator has configured a web filter profile and applied it to a policy; however, the web filter is not inspecting any traffic that is passing through the policy.

What must the administrator change to fix the issue?

41. A FortiGate is rebooting unexpectedly without any apparent reason.

What troubleshooting tools could an administrator use to get more information about the problem? (Choose two.)

42. Refer to the exhibits, which show the configuration on FortiGate and partial internet session information from a user on the internal network.

An administrator would like to test session failover between the two service provider connections.

What changes must the administrator make to force this existing session to immediately start using the other interface? (Choose two.)

43. Which statement about IKE and IKE NAT-T is true?

44. An administrator cannot connect to the GIU of a FortiGate unit with the IP address 10.0.1.254. The administrator runs the debug flow while attempting the connection using HTTP.

The output of the debug flow is shown in the exhibit:

Based on the error displayed by the debug flow, which are valid reasons for this problem? (Choose two.)

45. View the exhibit, which contains the output of a debug command, and then answer the question below.

Which of the following statements about the exhibit are true? (Choose two.)

46. Refer to the exhibit, which contains the output of a debug command.

If the default settings are in place, what can be concluded about the conserve mode shown in the exhibit?

47. View the exhibit, which contains a partial web filter profile configuration, and then answer the question below.

Which action will FortiGate take if a user attempts to access www.dropbox.com, which is categorized as File Sharing and Storage?

48. Which of the following statements are true regarding the SIP session helper and the SIP application layer gateway (ALG)? (Choose three.)

49. An administrator has configured two FortiGate devices for an HA cluster. While testing HA failover, the administrator notices that some of the switches in the network continue to send traffic to the former primary device.

What can the administrator do to fix this problem?

50. Examine the output of the ‘diagnose ips anomaly list’ command shown in the exhibit; then answer the question below.

Which IP addresses are included in the output of this command?

51. Which two statements about the Security Fabric are true? (Choose two.)

52. View the exhibit, which contains the output of a debug command, and then answer the question below.

Which one of the following statements about this FortiGate is correct?

53. Which the following events can trigger the election of a new primary unit in a HA cluster? (Choose two.)

54. Examine the output of the ‘get router info bgp summary’ command shown in the exhibit; then answer the question below.

Which statements are true regarding the output in the exhibit? (Choose two.)

55. Refer to the exhibit, which contains the output of a BGP debug command.

Which statement about the exhibit is true?

56. What is the purpose of an internal segmentation firewall (ISFW)?

57. Which two tasks are automated using the Install Wizard on FortiManager? (Choose two.)

58. Refer to the exhibit, which contains the partial output of the get vpn ipsec tunnel details command.

Based on the output, which two statements are correct? (Choose two.)

59. Which two tasks are automated using the Import Configuration wizard on FortiManager? (Choose two.)

60. An administrator has configured a dial-up IPsec VPN with one phase 2, extended authentication (XAuth) and IKE mode configuration.

The administrator has also enabled the IKE real time debug:

diagnose debug application ike-1

diagnose debug enable

In which order is each step and phase displayed in the debug output each time a new dial-up user is connecting to the VPN?


 

New NSE6_FWB-6.4 Dumps Online For Fortinet NSE 6 - FortiWeb 6.4 Exam Preparation
Updated NSE7_SDW-6.4 Dumps Questions To Be The Important Preparation Resource Online

Add a Comment

Your email address will not be published. Required fields are marked *