Huawei H35-581_V2.0-ENU Dumps (V9.02) Are Useful to Prepare for Your HCIP-5G-RNP&RNO V2.0 Exam – Read H35-581_V2.0-ENU Free Dumps (Part 1, Q1-Q40) First

1. Which of the following is not a process for PUCCH channel management?

2. Which of the following descriptions about 5G PRACH is correct?

3. Which of the following is not a 5G voice solution?

4. Which of the following in the terminal capability report indicates that the terminal supports?

5. Which of the following descriptions about the frequency domain location of the PRACH channel is correct?

6. Which of the following descriptions about EN-DC dual connection networking is incorrect?

7. The 5G frequency grid defines the central frequency of the NR cell. What is 4FG1oba1 in the frequency number calculation formula of Sub3G?

8. How long does it take for the UE to transition from RRC INACTIVE to RRC_IDLE if there is no service and the serving gNodeB does not change?

9. 5G PUSCH supports two waveforms: CP-OFDM and DFT-S-OFDM. Which of the following descriptions is incorrect?

10. Which of the following events is used by the gNodeB to perform the target cell or target frequency decision based on coverage inter-frequency handover?

11. In DRAN networking, which transmission solution is recommended for the fronthaul interface?

12. Which of the following processes is not included in the UE initial registration process?

13. Which of the following scenarios regarding SU-MIMO is incorrect?

14. Which of the following descriptions about MU-MIMO pairing is incorrect?

15. What does it mean if the terminal receives a TA value of 40 in the SA cell?

16. Comparing QoS and slice SLA, which of the following descriptions is incorrect?

17. Which of the following information does the self-optimization function of ultra-distant neighbor identification not refer to when optimizing neighbor attributes?

18. If the maximum transmit power of a cell is 100W, SCS=30kHz, bandwidth is 100MHz, and 64T64R AAU is used, what is the approximate cell reference power?

19. Which of the following requirements is an entry condition for the A3 event?

20. Which of the following events is used by the gNodeB to determine the target cell or target frequency for service-based inter-frequency handover?

21. Low MCS is a common problem that causes low downlink rate. Which of the following descriptions about low MCS is incorrect?

22. In the Option 3x architecture, which protocol layer is responsible for data diversion?

23. Which information is not included in the parameter PRACH Configuration lndex?

24. In a scenario where the 5G cell bandwidth is 100MHz and the subcarrier spacing SCS is 30KHz, what is the minimum protection bandwidth?

25. Which transmission method does Huawei base station CSI-RS for BM currently support?

26. Which of the following protocol layers completes the resource scheduling on the base station side?

27. Among the following PDSCH DMRS configuration schemes, which one has the largest overhead?

28. Which parameter in the MIB message indicates the number of time domain symbols of CORESETO?

29. In the LNR time synchronization scenario, what is the maximum LTE power when the uplink subframe is concurrent?

30. Which of the following signaling is used to release a PDU session initiated by the base station?

31. Which of the following is not included in the QoS flow involved in IMS video services?

32. When troubleshooting NR cell interference with SCS=30kHz, what is the normal interference noise floor at the PRB level?

33. What link does blind switching not include compared to normal switching?

34. Which of the following descriptions of Huawei SA cell context abnormal release scenarios is incorrect?

35. Which of the following descriptions about codeword stream mapping is incorrect?

36. When the NR cell subcarrier spacing SCS = 30KHz, what is the maximum number of PDCCH blind detections?

37. The logical channel is located between the MAC layer and the RLC layer. Which of the following does not belong to the control channel?

38. Which piece of information will not be referenced by the automatic deletion of neighbor relations feature?

39. In which of the following scenarios will Huawei base station carrier aggregation delete SCell?

40. Assuming that the SSB physical layer period is configured to be 10ms, how many SSB scans are required for the same MIB block?