HPE6-A72 Dumps (V10.02) Updated – Ensure Your Success in the Aruba Certified Switching Associate Exam Before December 16, 2024

The Aruba Certified Switching Associate (ACSA) HPE6-A72 exam is important for validating your knowledge of HPE Aruba Networking Switching Fundamentals. This certification demonstrates your ability to build HPE Aruba Networking-based solutions for both small-to-midsized businesses (SMBs) and campus networks. It is retiring on December 16, 2024, so you must complete it before that day. DumpsBase updated the HPE6-A72 dumps to V10.02 with 88 practice exam questions and answers for learning. The updated HPE6-A72 exam dumps provide you with accurate and up-to-date information to ensure your success. Utilize our HPE6-A72 dumps to familiarize yourself with the question format and assess your knowledge. By following a structured study plan and utilizing DumpsBase’s updated HPE6-A72 dumps (V10.02), you can increase your chances of success.

Aruba Certified Switching Associate (ACSA) Certification Exam HPE6-A72 Free Dumps Below

1. Refer to the exhibit.

You are in the process of configuring VSF between Access-1 and Access-2. Access-1 has been configured as the VSF Master.

What is a valid configuration for Access-2 to join the VSF stack?

2. What are two primary concerns regarding layer two loops in a redundant topology? (Choose two.)

3. Which port or ports should be allowed through a firewall so that an AOS-CX switch can act as an SNMP Agent?

4. Refer to the exhibit.

Traffic is failing between Core-1 and Host-B. IP addressing has correctly been applied, and all interfaces are attached to the vrf GREEN.

Which configuration will correct the issue?

5. DRAG DROP

Match the term to the correct description.

6. What is Deep Packet Inspection?

7. What is the binary conversion of the hexadecimal value 0x2001?

8. You need to remote into an AOS-CX switch using SSH in order to update the management IP address for future connections. Unfortunately, you mis-configured the IP address and are now locked out of the switch.

What command could you have issued before making changes that would have recovered the original switch configuration after ten minutes?

9. The following command is issued:

Switch# checkpoint rollback start

What is the result?

10. Refer to the exhibit.

The above output is the result of issuing the command show system resource-utilization.

What command should be used to enable terminal output line by line or page by page?

11. The section in blue can be ignored.

SW1(config)# interface 1/1/1-1/1/2

SW1(config-if-<1/1/1-1/1/2)# vlan access 2

SW1(config-if-<1/1/1-1/1/2)# exit

SW1(config)# interface 1/1/11-1/1/17

SW1(config-if-<1/1/11-1/1/17)# vlan access 17

SW1(config-if-<1/1/11-1/1/17)# exit

After completing the above commands, what is the expected output of show vlan with no other vlan commanded having been added?

12. Which security benefit does SNMPv3 offer that SNMPv2 does not offer?

13. Refer to the exhibit

Which command on Access-2 port 1/1/4 will enable connectivity between PC-1 and Server-1 without any routing enabled in the network?

14. Refer to the exhibit.

The Aruba 8400 in the exhibit is member 2 of a VSX stack.

Which command will enter the interface sub configuration mode for the port, indicated by the orange square?

15. What command displays information regarding the secondary image installed on an AOS-CX switch?

16. DRAG DROP

Match the available stacking feature to the correct AOS-CX switch model. Stacking features may be used more than once.

17. Which switches support Aruba Virtual Switching Extension (VSX)? (Choose two.)

18. Which option correctly describes a WAN network?

19. Which two statements accurately describe the features of NetEdit? (Choose two.)

20. Refer to the exhibit.

What command (output shown above) gives the optics serial number and part number information?

21. ServiceOS login: admin

SVOS> password

Enter password: ********

Confirm password: ********

The login password to access an Aruba AOS-CX was lost. After connecting to the switch console port, a reboot is performed and the Service OS console is accessed as shown above.

What is the default password that is required for the admin account while under the Service OS console?

22. Refer to the exhibit.

What commands will successfully enable the SVI for vlan 100 on interface 1/1/1 to produce the results displayed in the command show ip interface brief in the exhibit below?

23. What is an available command on an Aruba AOS-CX switch that would back up the secondary image to a secure remote repository?

24. Which two options are correct regarding the IEEE 802.11ax standard? (Choose two.)

25. What are two mechanisms supported on AOS-CX 6300 switches used in Multi-active Detection to determine the status of the Primary member? (Choose two.)

26. What is a benefit of choosing a 3-Tier design with routing at the Aggregation layer?

27. Which two statements are true regarding Checkpoints on Aruba switches? (Choose two.)

28. DRAG DROP

Match each description to the correct management tool for Aruba AOS-CX.

29. What are two OSPF attributes within the hello messages that must match to successfully establish neighbor relationships? (Choose two.)

30. Refer to the exhibit.

The above scenario shows a packet from the Server destined for the Firewall. Switch-A and Switch-B are bundled as VSF stack. The LAG between the VSF stack and the firewall indicates a hash function to forward the packet on port 2/1/2.

Which statement is true regarding how Switch-A will forward the packet?

31. Which statement is correct regarding powering an Aruba Access Point?


 

HPE0-J68 Dumps Updated (V11.02) - DumpsBase Gives You the Right Preparation Guide for HPE Storage Solutions Exam Preparation
Updated HPE0-S59 Dumps (V10.02) - Study with the Latest HPE0-S59 Exam Questions and Answers to Enhance Your Skills and Knowledge

Add a Comment

Your email address will not be published. Required fields are marked *