Get VMware VCP-NV 202 Exam 2V0-41.20 Dumps In PDF File

1. An NSX administrator noticed that the nsxclicommand times out after 600 secs of idle time.

Which CLI command disables the nsxcli time out value on NSX Manager?

2. An NSX administrator is configuring the KVM hypervisor host as a transport node and wants to apply the Failover Order as a NIC teaming policy.

Which profile allows the administrator to configure the NIC Teaming policy as Failover Order?

3. Which two choices are prerequisites to configure NSX-T on VDS? (Choose two.)

4. Which command is used to display the network configuration of the Tunnel Endpoint (TEP) IP on a bare metal transport node?

5. Which three steps are required to create an IPsec VPN tunnel? (Choose three.)

6. An NSX administrator wants to create a Tier-0 Gateway to support equal cost multi-path (ECMP) routing.

Which failover detection protocol must be used to meet this requirement?

7. What are two supported N-VDS modes? (Choose two.)

8. A user is assigned these two roles in NSX Manager:

- LB Admin

- Network Engineer

What privileges does this user have in the system?

9. An NSX administrator has configured a KVM hypervisor as a transport node.

Which kernel module on KVM implements a N-VDS?

10. Which CLI command should be executed on a KVM hypervisor to retrieve the VM interface UUID?

11. What are two types of supported IPSec VPNs in NSX-T Data Center? (Choose two.)

12. Which two choices are use cases for Distributed Intrusion Detection? (Choose two.)

13. An NSX administrator has been tasked with deploying a NSX Edge Virtual machine through an ISO image.

Which virtual network interface card (vNIC) type must be selected while creating the NSX Edge VM allow participation in overlay and VLAN transport zones?

14. What needs to be configured on a Tier-0 Gateway to make NSX Edge Services available to a VM on a VLAN-backed logical switch?

15. Which CLI command does an NSX administrator run on the NSX Manager to generate support bundle logs if the NSX UI is inaccessible?

16. An NSX administrator would like to export syslog events that capture messages related to NSX host preparation events.

Which message ID (msgid) should be used in the syslog export configuration command as a filter?

17. Which CLI command shows syslog on NSX Manager?

18. Which three protocols could an NSX administrator use to transfer log messages to a remote log server? (Choose three.)

19. Which command is used to set the NSX Manager's logging-level to debug mode for troubleshooting?

20. The NSX Control Plane is responsible for which two functions? (Choose two.)