FREE H12-211-ENU HCNA-HNTD Real Exam Dumps

1. Refer to the following BHCP flow diagram, which of the following statement is correct? ( ) (Multiple choice)

2. On a router to act as an authentication server configured with two authentication domain "Area 1" and "Area 2", if the user using the correct user name "huawei" and the password "hello" for authentication, then which authentication domain will the user be assigned to ?

3. Under the RIP process of Huawei equipment, declared network 10.1.1.1/30, which of the following configuration is correct? ( ) (Multiple choice)

4. VRP system login timeout time should be set under the VTY interface.

5. NAPT is through TCP or UDP or IP packets in the protocol number to distinguish the different user's IP address.

6. There are two routers RTA and RTB from the source device to the destination device, use the Tracert command to test the path. When detecting the first jump RTA, the source device to a large port of the destination device to send a UDP packet with a TTL of 1, when the packet arrives in RTB, TTL becomes 0, so the RTA respond a ICMP_________ message to the source device .

7. About the corresponding relation of access control list numbers and types, Which of the following description is true ? ( )

8. The following two configuration commands can realize router standby backup to the same destination 10.1.1.0:

[RTA] ip route-static 10.1.1.0 24 12.1.1.1 permanent

[RTA] ip route-static 10.1.1.0 24 13.1.1.1

9. ALC will not filter equipment itself generated traffic which access to other devices; only filter forward traffic, in the forwarding traffic includes traffic which other devices access the device.

10. About the static and dynamic routing, which of the following statement is not correct?

11. Refer to the following topology and configuration, the router R1 and R2 connect via Serial low-speed cable, and the data link layer encapsulation using PPP. When R1 and R2 Holdtime inconsistent, APP negotiation fails, can not communicate.

12. 00% packet loss

round-trip min/avg/max = 2/6/10 ms

Network administrators use the Ping command on the AR G3 series routers to test the connectivity reaching 10.0.0.2, which of the following description of the output is correct? ( )

13. Network administrator configures RIPng protocol in a small IPvs network, which of the following configuration is correct and effective?

14. In IPv6 network, Which of the following characteristics does OSPPv3 no longer support ?

15. On VRP platform, which command is used to set up data link layer encapsulation type to HDLC on the Serial port?

16. Make an IP address 10.0.0.1 host access to the Internet, which is the necessary technology?

17. Which of the following versions of SNMP protocol support encryption feature?

18. In STP, assuming that all switches are configured the same priority, switch1 MAC address is 00-e04c-00-00-40, switch 2 MAC address is 00-e0-fc-00-00-10, switch3 MAC address is 00-e0-fc-00-00-20, switch4 MAC address is 00-e0-fc-00-00-80, the root switch should be ( ).

19. AS shown, create VLAN2 on the SWA and SWB, configure the port connection to the host as Access Port, and blong to VLAN2. The SWA's G0/0/1 and SWB's G0/0/2 are both Trunk Port, and allow all VLAN.

If you want the normal communication between the host, the network administrator needs to ( ).

20. When using FTP protocol to upgrade router software, which transmission mode should be used?