FREE E20-385 Data Domain Specialist Implementation Engineers Questions

E20-385 Data Domain Specialist Exam for Implementation Engineers exam focuses on installation, integration, and administration of Dell EMC Data Domain systems. You should complete exam questions of E20-385 Data Domain Specialist Exam for Implementation Engineers exam in 90 minutes.

How many E20-385 exam topics you should pay attention to?
Data Domain Fundamentals (15%)
Data Domain Hardware Installation (15%)
Data Domain Extended Retention: Installation, Configuration, and Administration (10%)
Data Domain Cloud Tier Installation, Configuration, and Administration (10%)
Data Domain Implementation in Backup Environments and Integration with Application Software (15%)
Data Domain System Administration (35%)

It’s FREE to read the following Dell EMC E20-385 certification exam.

1. In which path location are Autosupport logs stored on an EMC Data Domain system?

2. You are responsible for capacity planning in an EMC Data Domain environment. While monitoring space usage over a series of weeks, you notice a sudden increase in space consumption. The new rate of consumption will require additional capacity.
What is the most likely cause?

3. A customer's EMC Data Domain system reports a global compression ratio of 7.8x. This does not meet the customer’s expectations.
What can be done to increase the data reduction ratio?

4. An EMC Data Domain system has been installed at a customer's site for several months and has reached steady state. At which threshold percent does capacity reach the point where action should be taken to make more free space available?

5. When monitoring EMC Data Domain systems, an administrator sees the System Manager File System Summary showing a compression factor of 20x. How is the equivalent value shown in the "Reduction%" column?

6. What is a benefit of snapshots on an EMC Data Domain system?

7. On an EMC Data Domain system, what is the role of file system cleaning?

8. A company is replicating two specific directories between two EMC Data Domain systems using a 4 Mb/s WAN connection. What can be done on the Data Domain systems to maximize replication performance?

9. When logging into an EMC Data Domain system during an initial installation, which connection type must be used?

10. After backups are expired and data is marked for deletion, when is space freed up on an EMC Data Domain file system?

11. Refer to Exhibit.


An EMC Data Domain customer has three offices with their payroll backups currently located in San Jose, California. They want to plan a disaster recovery strategy. The customer is concerned with the possibility of multiple disasters that could compromise both the source and destination sites simultaneously.
Which replication topology will address the customer's concerns about availability and RTO?

12. Refer to the exhibit.


You are installing an EMC Data Domain system with expansion shelves. When is the cable connector shown in the exhibit used?

13. Refer to the exhibit


You are installing an EMC Data Domain system with expansion shelves. When is the cable connector shown in the exhibit used?

14. Refer to the exhibit.


When monitoring the system show stats command output, you notice that the "Disk Write KiB/s" column does not have same data rate as "Net eth0a in MB/s" column. What is a possible reason for this behavior?

15. Refer to the exhibit.


When monitoring the system show performance command output, you notice that the state column has "D" for each line entry. What does the "D" in the "State" column indicate?

16. Refer to the Exhibit.


On the EMC Data Domain system, what is the approximate amount of data sent to the system on November 11th?

17. Refer to the Exhibit.


Between February 27th and March 4th, what is the highest compression factor reached (approximately) on the EMC Data Domain system?

18. Refer to the Exhibit.


On the EMC Data Domain system, what is the approximate amount of disk space consumed on November 11?

19. Refer to the Exhibit.


On the EMC Data Domain system, what is the approximate amount of data sent to the system on March 2nd?

20. Refer to the exhibit.


Based on the exhibit, what does the difference between the inbound network rate and writes to disk indicate on the EMC Data Domain system?


 

 

 

 

FREE E20-393 DELL EMC Implementation Engineer (EMCIE) Dumps Questions
FREE to View E20-357 DECS-IE DELL EMC Dumps Questions

Add a Comment

Your email address will not be published. Required fields are marked *