Choose HPE7-A01 Dumps to Prepare for Aruba Certified Campus Access Professional Exam

1. Your Aruba CX 6300 VSF stack has OSPF adjacency over SVI 10 with LAG 1 to a neighboring device.

The following configuration was created on the switch:

A)

B)

C)

D)

2. The customer needs a network hardware refresh to replace an aging Aruba 5406R core switch pair using spanning tree configuration with Aruba CX 8360-32YC switches.

What is the benefit of VSX clustering with the new solution?

3. What is enabled by LLDP-MED? (Select two.)

4. A company deployed Dynamic Segmentation with their CX switches and Gateways After performing a security audit on their network, they discovered that the tunnels built between the CX switch and the Aruba Gateway are not encrypted. The company is concerned that bad actors could try to insert spoofed messages on the Gateway to disrupt communications or obtain information about the network.

Which action must the administrator perform to address this situation?

5. What is true regarding 802.11k?

6. What is an Aruba-recommended best practice for hardening that only applies to Aruba CX 6300 series switches with dedicated management ports?

7. A customer is using stacked Aruba CX 6200 and CX 6300 switches for access and a VSX pair of Aruba CX 8325 as a collapsed core 802 1X is implemented for authentication. Due to the lack of cabling, some unmanaged switches are still in use Sometimes devices behind these switches cause network outages The switch should send a warning to the helpdesk when the problem occurs You have been asked to implement an effective solution to the problem.

What is the solution for this?

8. Which feature supported by SNMPv3 provides an advantage over SNMPv2c?

9. You are configuring Policy Based Routing (PBR) for a subnet that will be used to test a new default route for your network Traffic originating from 10.2.250.0/24 should use a new default route to 10.1.1.253. Other non-default routes for this subnet should not be affected by this change.

What are two parts of the solution for these requirements? (Select two.)

A)

B)

C)

D)

E)

10. Two AOS-CX switches are configured with VSX at the the Access-Aggregation layer where servers attach to them An SVI interface is configured for VLAN 10 and serves as the default gateway for VLAN 10. The ISL link between the switches fails, but the keepalive interface functions. Active gateway has been configured on the VSX switches.

What is correct about access from the servers to the Core? (Select two.)

11. What is an OSPF transit network?

12. Which Aruba AP mode is sending captured RF data to Aruba Central for waterfall plot?

13. You need to create a keepalive network between two Aruba CX 8325 switches for VSX configuration How should you establish the keepalive connection?

14. Which method is used to onboard a new UXI in an existing environment with 802 1X authentication? (The sensor has no cellular connection)

15. How is Multicast Transmission Optimization implemented in an HPE Aruba wireless network?

16. You need lo have different routing-table requirements with Aruba CX 6300 VSF configuration Assuming the correct layer-2 VLAN already exists how would you create a new OSPF configuration for a separate routing table?

17. A customer has a large number of food-producing machines

* All machines are connected via Aruba CX6200 switches in VLANs 100.110. and 120

* Several external technicians are maintaining this special equipment

What are the correct commands to ensure that no rogue DHCP server will impact the network?

A)

B)

C)

D)

18. In an ArubaOS 10 architecture using an AP and a gateway, what happens when a client attempts to join the network and the WLAN is configured with OWE?

19. Describe the difference between Class of Service (CoS) and Differentiated Services Code Point (DSCP).

20. A customer is using a legacy application that communicates at layer-2. The customer would like to keep this application working across the campus which is connected via layer-3. The legacy devices are connected to Aruba CX 6300 switches throughout the campus.

Which technology minimizes flooding so the legacy application can work efficiently?

21. A network engineer recently identified that a wired device connected to a CX Switch is misbehaving on the network To address this issue, a new ClearPass policy has been put in place to prevent this device from connecting to the network again.

Which steps need to be implemented to allow ClearPass to perform a CoA and change the access for this wired device? (Select two.)

22. You are doing tests in your lab and with the following equipment specifications

* AP1 has a radio that generates a 10 dBm signal

* AP2 has a radio that generates a 11 dBm signal

* AP1 has an antenna with a gain of 9 dBi

* AP2 has an antenna with a gain of 12 dBi.

* The antenna cable for AP1 has a 2 dB loss

* The antenna cable for AP2 has a 3 dB loss

What would be the calculated Equivalent Isotropic Radiated Power (EIRP) for APT?

23. A system engineer needs to preconfigure several Aruba CX 6300 switches that will be sent to a remote office An untrained local field technician will do the rollout of the switches and the mounting of several AP-515s and AP-575S. Cables running to theAPs are not labeled.

The VLANs are already preconfigured to VLAN 100 (mgmt), VLAN 200 (clients), and VLAN 300 (guests).

What is the correct configuration to ensure that APs will work properly?

A)

B)

C)

24. In AOS 10. which session-based ACL below will only allow ping from any wired station to wireless clients but will not allow ping from wireless clients to wired stations"? The wired host ingress traffic arrives on a trusted port.

25. A new network design is being considered to minimize client latency in a high-density environment. The design needs to do this by eliminating contention overhead by dedicating subcamers to clients.

Which technology is the best match for this use case?