2024 (Newest) HPE7-A01 Dumps V14.03 – Ensuring that You Are Well-Prepared and Confident for the HPE7-A01 Exam

1. Your Aruba CX 6300 VSF stack has OSPF adjacency over SVI 10 with LAG 1 to a neighboring device.

The following configuration was created on the switch:

A)

B)

C)

D)

2. The customer needs a network hardware refresh to replace an aging Aruba 5406R core switch pair using spanning tree configuration with Aruba CX 8360-32YC switches.

What is the benefit of VSX clustering with the new solution?

3. You need to ensure that voice traffic sent through an ArubaOS-CX switch arrives with minimal latency What is the best scheduling technology to use for this task ? (Select two.)

4. A company deployed Dynamic Segmentation with their CX switches and Gateways After performing a security audit on their network, they discovered that the tunnels built between the CX switch and the Aruba Gateway are not encrypted. The company is concerned that bad actors could try to insert spoofed messages on the Gateway to disrupt communications or obtain information about the network.

Which action must the administrator perform to address this situation?

5. What is true regarding 802.11k?

6. What is an Aruba-recommended best practice for hardening that only applies to Aruba CX 6300 series switches with dedicated management ports?

7. A customer is using stacked Aruba CX 6200 and CX 6300 switches for access and a VSX pair of Aruba CX 8325 as a collapsed core 802 1X is implemented for authentication. Due to the lack of cabling, some unmanaged switches are still in use Sometimes devices behind these switches cause network outages The switch should send a warning to the helpdesk when the problem occurs You have been asked to implement an effective solution to the problem.

What is the solution for this?

8. Which feature supported by SNMPv3 provides an advantage over SNMPv2c?

9. You are configuring Policy Based Routing (PBR) for a subnet that will be used to test a new default route for your network Traffic originating from 10.2.250.0/24 should use a new default route to 10.1.1.253. Other non-default routes for this subnet should not be affected by this change.

What are two parts of the solution for these requirements? (Select two.)

A)

B)

C)

D)

E)

10. Two AOS-CX switches are configured with VSX at the the Access-Aggregation layer where servers attach to them An SVI interface is configured for VLAN 10 and serves as the default gateway for VLAN 10. The ISL link between the switches fails, but the keepalive interface functions. Active gateway has been configured on the VSX switches.

What is correct about access from the servers to the Core? (Select two.)

11. What is an OSPF transit network?

A. a network that uses tunnels to connect two areas

B. a special network that connects two different areas

C. a network on which a router discovers at least one neighbor

D. a network that connects to a different routing protocol

12. Which Aruba AP mode is sending captured RF data to Aruba Central for waterfall plot?

13. You need to create a keepalive network between two Aruba CX 8325 switches for VSX configuration How should you establish the keepalive connection?

14. Which method is used to onboard a new UXI in an existing environment with 802 1X authentication? (The sensor has no cellular connection)

15. How is Multicast Transmission Optimization implemented in an HPE Aruba wireless network?

16. You need lo have different routing-table requirements with Aruba CX 6300 VSF configuration Assuming the correct layer-2 VLAN already exists how would you create a new OSPF configuration for a separate routing table?

17. A customer has a large number of food-producing machines

* All machines are connected via Aruba CX6200 switches in VLANs 100.110. and 120

* Several external technicians are maintaining this special equipment

What are the correct commands to ensure that no rogue DHCP server will impact the network?

A)

B)

C)

D)

18. In an ArubaOS 10 architecture using an AP and a gateway, what happens when a client attempts to join the network and the WLAN is configured with OWE?

19. Describe the difference between Class of Service (CoS) and Differentiated Services Code Point (DSCP).

20. A customer is using a legacy application that communicates at layer-2. The customer would like to keep this application working across the campus which is connected via layer-3. The legacy devices are connected to Aruba CX 6300 switches throughout the campus.

Which technology minimizes flooding so the legacy application can work efficiently?

21. A network engineer recently identified that a wired device connected to a CX Switch is misbehaving on the network To address this issue, a new ClearPass policy has been put in place to prevent this device from connecting to the network again.

Which steps need to be implemented to allow ClearPass to perform a CoA and change the access for this wired device? (Select two.)

22. You are doing tests in your lab and with the following equipment specifications

* AP1 has a radio that generates a 10 dBm signal

* AP2 has a radio that generates a 11 dBm signal

* AP1 has an antenna with a gain of 9 dBi

* AP2 has an antenna with a gain of 12 dBi.

* The antenna cable for AP1 has a 2 dB loss

* The antenna cable for AP2 has a 3 dB loss

What would be the calculated Equivalent Isotropic Radiated Power (EIRP) for APT?

23. A system engineer needs to preconfigure several Aruba CX 6300 switches that will be sent to a remote office An untrained local field technician will do the rollout of the switches and the mounting of several AP-515s and AP-575S. Cables running to theAPs are not labeled.

The VLANs are already preconfigured to VLAN 100 (mgmt), VLAN 200 (clients), and VLAN 300 (guests).

What is the correct configuration to ensure that APs will work properly?

A)

B)

C)

24. In AOS 10. which session-based ACL below will only allow ping from any wired station to wireless clients but will not allow ping from wireless clients to wired stations"? The wired host ingress traffic arrives on a trusted port.

A. ip access-list session pingFromWired any user any permit

B. ip access-list session pingFromWired user any svc-icmp deny any any svc-icmp permit

C. ip access-list session pingFromWired any any svc-icmp permit user any svc-icmp deny

D. ip access-list session pingFromWired any any svc-icmp deny any user svc-icmp permit

25. A new network design is being considered to minimize client latency in a high-density environment. The design needs to do this by eliminating contention overhead by dedicating subcamers to clients.

Which technology is the best match for this use case?

26. What is a primary benefit of BSS coloring?

27. Your manufacturing client is having installers deploy seventy headless scanners and fifty IP cameras in their warehouse These new devices do not support 802 1X authentication.

How can HPE Aruba reduce the IT administration overhead associated with this deployment while maintaining a secure environment using MPSK?

A. Have the installers generate keys with ClearPass Self Service Registration.

B. Have the MPSK gateway derive the unique pre-shared keys based on the MAC OUI.

C. Use MPSK Local to automatically provide unique pre-shared keys for devices.

D. MPSK Local will allow the cameras to share a key and the scanners to share a different key

28. What is the order of operations tor Key Management service for a wireless client roaming from AP1 to AP2?

29. When setting up an Aruba CX VSX pair, which information does the Inter-Switch Link Protocol configuration use in the configuration created?

30. Select the Aruba stacking technology matching each option (Options may be used more than once or not at all.)

31. Review the exhibit.

You are troubleshooting an issue with a 10 102.39 0/24 subnet which is also VLAN 1000 used Tor wireless clients on a pair of Aruba CX 8360 switches The subnet SVI is configured on the 8360 pair, and the DHCP server is a Microsoft Windows Server 2022 Standard with an IP address of 10 200 1.100. The 10.102.250.0/24 subnet is used for switch management.

A large number of DHCP requests are failing You are observing sporadic DHCP behavior across clients

attached to the CX 6100 switch.

Which action may help fix the issue?

A)

B)

C)

D)

32. The administrator notices that wired guest users that have exceeded their bandwidth limit are not being disconnected Access Tracker in ClearPass indicates a disconnect CoA message is being sent to the AOS-CX switch.

An administrator has performed the following configuration

What is the most likely cause of this issue?

33. You are helping an onsite network technician bring up an Aruba 9004 gateway with ZTP for a branch office The technician was to plug in any port for the ZTP process to start Thirty minutes after the gateway was plugged in new users started to complain they were no longer able to get to the internet. One user who reported the issue stated their IP address is 172.16 0.81 However, the branch office network is supposed to be on 10.231 81.0/24.

What should the technician do to alleviate the issue and get the ZTP process started correctly?

34. Your Director of Security asks you to assign AOS-CX switch management roles to new employees based on their specific job requirements After the configuration was complete, it was noted that a user assigned with the administrators role did not have the appropriate level of access on the switch.

The user was not limited to viewing nonsensitive configuration information and a level of 1 was not assigned to their role.

Which default management role should have been assigned for the user?

35. A company recently deployed new Aruba Access Points at different branch offices Wireless 802.1X authentication will be against a RADIUS server in the cloud. The security team is concerned that the traffic between the AP and the RADIUS server will be exposed..

What is the appropriate solution for this scenario?

36. You are deploying a bonded 40 MHz wide channel.

What is the difference in the noise floor perceived by a client using this bonded channel as compared to an unbonded 20MHz wide channel?

37. Using Aruba best practices what should be enabled for visitor networks where encryption is needed but authentication is not required?

38. Describe the difference between Class of Service (CoS) and Differentiated Services Code Point (DSCP).

39. You are configuring an SVI on an Aruba CX switch that needs to have the following characteristics:

* VLANID = 25

. IPv4 address 10 105 43 1 with mask 255 255 255.0

* IPv6 address fd00:5708::f02d:4df6 with a 64 bit prefix length

* member of VRF eng

* VRF eng and VLAN 25 have not yet been created

Which command lists will satisfy the requirements with the least number of commands?

A)

B)

C)

D)

40. Due to a shipping error, five (5) Aruba AP-515S and one (1) Aruba CX 6300 were sent directly to your new branch office You have configured a new group persona for the new branch office devices in Central, but you do not know their MAC addresses or serial numbers The office manager is instructed via text message on their smartphone to onboard all the new hardware into Aruba Central.

What application must the office manager use on their phone to complete this task?

41. Match the terms below to their characteristics (Options may be used more than once or not at all.)

42. What steps are part of the Key Management workflow when a wireless device is roaming

from AP1 to AP2? (Select two.)

43. Which statement best describes QoS?

44. A customer wants to enable wired authentication across all their CX switches One of the requirements is that the switch must be able to authenticate a single computer connected through a VoIP phone.

Which feature should be enabled to support this requirement?

45. Match the solution components of NetConductor (Options may be used more than once or not at all.)