2020 Real HPE0-S58 Dumps – Implementing HPE Composable Infrastructure Solutions Exam

1. During an initial setup of a Synergy environment, an integrator needs to enable or disable authorized Service access.

What will be the outcome when the integrator disables this service?

2. FILL BLANK

A customer has the following configuration:

Frame 1

– Bay 1 C HPE Synergy 12Gb SAS Connection Module

– Bay 2

– Bay 3 C HPE Virtual Connect SE 40 GB F8 Module

– Bay 4 C HPE Synergy 12GB SAS Connection Module

– Bay 5

– Bay 6 C HPE Synergy 10 Gb Interconnect Link Module

Frame 2

– Bay 1 C HPE Synergy 12Gb SAS Connection Module

– Bay 2

– Bay 3 C HPE Synergy 10Gb Interconnect Link Module

– Bay 4 C HPE Synergy 12Gb SAS Connection Module

– Bay 5

– Bay 6 C HPE Virtual Connect SE 40Gb F8 Module

How many more frames can the customer add to their Synergy composable fabric? (Note: Enter your answer in the answer field below.)

3. In a 3-frame HPE Synergy environment, how should an integrator place the image Streamer modules to allow for redundancy to all of the management connections?

4. What must an integrator do before an existing cluster can be imported to the HPE Composer?

5. Refer to the exhibit.

How should an integrator pair interconnect bays to set up redundant fabrics in an HPE Synergy 12000 Frame?

6. Refer to the exhibit.

An integrator needs to add an FCoE connection to the server profile, but the FCoE connection type is not available.

What is the likely cause of this issue?

7. An integrator is installing three Synergy frames in different locations for a customer. As part of the installation, the customer requests a single monitoring dashboard that shows the current hardware status, warranty status, and open support cases of all three frames.

Which configuration steps must the integrator perform to provide the customer with this functionality?

8. What are valid uses for an IPv4 address pool when configuring an HPE Synergy solution? (Choose two.)

9. HOTSPOT

A customer has the following HPE Synergy solution:

– three Synergy frames

– two HPE Virtual Connect SE 32Gb Fibre Channel (FC) modules in each time

– two HPE Virtual Connect SE 40GB F8 modules

– four HPE Synergy 10Gb Interconnect Link Modules

Click the menu option the integrator should use to add more uplinks ports from HPE Virtual Connect SE 32 Gb FC modules to SAN uplink set.

10. Which policy can an integrator apply when creating a datastore using HPE OneView for vCenter Server?

11. An integrator prepares deployment documents with the list of all the hardware and software components. The integrator also needs a list of all infrastructure services deployed, with the functionality described.

Which services are provided by the vCenter Server component and should be placed in the report? (Choose two.)

12. A customer needs to evaluate Image Streamer as Proof-of-Concept (PoC) in a test and development tab environment.

At a minimum, what does a Synergy integrator need in order to support this requirement?

13. Which component of the HPE Synergy solution should you use to set the firmware/driver baseline and the installation method for Synergy Compute nodes?

14. Which storage solution can be used for volume provisioning using HPE Composer?

15. What is the purpose of the OmniStack Accelerator card installed in HPE SimpliVity platform?