2019 HPE ACSP HPE6-A45 Dumps

1. Refer to the exhibit.

AOS-Switches will enforce 802.1X authentication on edge ports. The company has two RADIUS servers, which are meant to provide redundancy and load sharing of requests. The exhibit shows the planned RADIUS settings to deploy to the switches.

What should customers understand about this plan?

2. An administrator wants to ensure that an AOS-Switch forwards all traffic that it receives on interface 1 with high priority.

-Switches should also communicate the high priority to other switches across the traffic path.

The switch has type of service disabled.

The administrator plans to apply 802.1p priority 5 to interface 1.

What should the administrator check to ensure that the configuration will work properly?

3. Refer to the exhibit.

A network administrator sets up prioritization for an application that runs between Device 1 and Device 2.

However, the QoS for the application is not what the administrator expects.

How can the administrator check if the network infrastructure prioritizes traffic from Device 1 and Device 2?

4. Refer to the exhibits.

Exhibit 1.

Exhibit 2.

The exhibits show the current operational state for routes on Switch-3. The company wants Switch-3 to prefer the link to Switch-1 over the link to Switch-2 for all intra-area, inter-area, and external traffic.

What can the network administrator do to achieve this goal?

5. An AOS-Switch implements tunneled node.

Which benefit does the PAPI enhanced security key provide?

6. Refer to the exhibit.

A network administrator needs to deploy AOS-Switches that implement port-based tunneled node. Their Aruba controller has IP address 10.1.10.5/24. The architect has assigned tunneled-node endpoints to VLAN 20.

What is one issue with the current configuration planned for VLAN 20 on the switch?

7. OSPF Area 1 has two ABRs. One ABR is configured with this range for Area 1: 10.10.0.0/16. The other ABR is not configured with a range for Area 1.

Which type of issue occurs due to this mismatch?

8. Refer to the exhibits. Exhibit 1.

Exhibit 2.

The company wants to minimize congestion on Link 1.

Which spanning tree implementation meets this goal?

9. Refer to the exhibit.

The network administrator enables DHCP snooping globally and on VLAN 2. An additional step is mandatory for DHCP snooping to operate correctly and for clients to receive DHCP settings.

What is the additional mandatory step?

10. Refer to the exhibit.

A network administrator configures connection rate filtering on interface 1 with the throttle action. Device 1 crosses the threshold and triggers the action.

What does the switch do?

11. What must an OSPF router do to ensure nonstop routing should a standby member take over as commander when the original VSF commander fails?

12. Two AOS-Switches are directly interconnected. The network administrator wants to prevent broadcast storms and other Layer 2 issues that could occur if there is physical damage to a cable.

Which technology should the administrator implement on the connected switch interfaces?

13. Refer to the exhibit.

The routing switches shown in the exhibit run OSPF on the links between each other. The commander in the Switch-1 VSF fabric goes down. Traffic is disrupted for several seconds.

What should a network administrator do to support a faster failover in a similar situation?

14. Which benefit is provided by MD5 authentication for BGP?

15. Refer to the exhibits. Exhibit 1.

Exhibit 2.

The VoIP phone connects, authenticates successfully, and is dynamically assigned to tagged VLAN 6. The endpoint connected to the phone does not authenticate but starts to send untagged traffic.

How does the switch handle this traffic?

16. An AOS-Switch needs to be configured to support tunneled node in role-based mode. The Mobility Controller administrators tell the switch administrators that the AOS-Switch will integrate with a cluster of Mobility Controllers. The cluster virtual IP address is 10.1.1.10.

How should switch administrator integrate the AOS-Switch with the cluster?

17. Refer to the exhibit.

A company wants to change Area 1 shown in the exhibit from a stub area to a totally stub area.

What will be one effect of this planned change?

18. An AOS-Switch runs IGMP on A VLAN.

What is a requirement for the switch to be a potential IGMP querier on that VLAN?

19. Refer to the exhibit.

Switch-1 runs BGP.

What should the network administrator do to permit Switch-1 to establish a neighbor relationship with Router-1?

20. Refer to the exhibit.

An AOS-Switch has an extended ACL that is applied to several physical interfaces.

- New interfaces have been brought online.

- The ACL has been applied to them as well.

A network administrator sees the output in the exhibit and is concerned that the switch will reach the limit for rules.

What can the administrator do to address this concern?

21. Refer to the exhibit.

A company requires distribution layer switches that can provide Layer 2 and Layer 3 redundancy. The exhibit shows the proposal for these switches.

Which change to the proposal will help meet the company’s requirements?

22. Network administrators need to track when traffic matches deny entry in an ACL applied to a port. They want the alert to be sent to a syslog server that is already set up to send logs.

What should administrators do to enable alerts?

23. Refer to the exhibits.

Exhibit 1

Exhibit 2

In the exhibits, VLAN 20 under a device name indicates that the device is configured with that VLAN. The exhibits also indicate whether VLAN 20 is statically configured on each link, either as an untagged or a tagged VLAN. If the link has no label, VLAN 20 is not statically configured on that link.

A network administrator needs to deploy AOS-Switches that use port-based tunneled node. The plan calls for tunneled-node endpoints to be assigned to VLAN 20 and for the Aruba Mobility Controller to handle the tunneled-node traffic at Layer 2.

Which exhibit shows the correct plan for VLAN 20 in the wired infrastructure?

24. Refer to the exhibits.

Exhibit 1

Exhibit 2 Switch-1 has a power issue that causes it to fail. When Switch-1 comes back up, endpoints lose connectivity for a few minutes.

The network administrator decides to enter this command on Switch-1:

Switch-1 (config)# vlan 10 vrrp vrid 10 preempt-delay-time 120

Exhibit 2 shows the VRRP configuration just after the change.

What is the effect of this change?

25. Refer to the exhibits.

Exhibit 1

Exhibit 2

Exhibit 1 shows a portion of the BGP routing table when the BGP solution was first deployed. Exhibit 2

shows the same portion at the current time.

What can explain the current state?

26. Which switches can be deployed in a mesh topology for backplane stacking?

27. A network administrator needs to create a QoS policy on an AOS-Switch.

What is one component that the administrator must create before the policy?

28. Refer to the exhibits.

Exhibit 1

Exhibit 2

Switch-1 and Switch-2 are configured to provide VRRP in VLAN 2. The default gateway for VLAN 2 is set to the VRRP virtual IP. Client-1 in VLAN 2 cannot ping its default gateway.

Based on the exhibits, what can administrators determine?

29. A network administrator needs to create a backplane stack with four AOS-Switches. The administrator wants to choose which switch becomes the commander.

Which procedure meets those needs?

30. A company deploys AOS-Switches at sites with inexperienced IT staff. The main office network administrators want to monitor thresholds to generate alerts on branch switches.

What should be set up for this purpose?