Get the Most Updated JN0-682 Dumps (V10.02) to Prepare for Your Juniper Data Center, Professional (JNCIP-DC) Exam

1. Which two statements are correct about VXLANs? (Choose two.)

2. You are required to create an IP fabric for your new data center. In this scenario, which protocol would be used to support EVPN?

3. Which device provides microsegmentation in a data center network?

4. You are building an IP fabric underlay network for your new data center. You must ensure that you have predictable load-balancing behavior throughout your network.

According to Juniper Networks, what are two best practices that should be followed in this scenario? (Choose two.)

5. Which two statements are correct about VXLAN domains? (Choose two.)

6. You want to improve network convergence within a data center during link failures. In this scenario, which EVPN-VXLAN feature will accomplish this task?

7. Which IP fabric underlay protocol provides the highest degree of scalability?

8. Referring to the exhibit, which two statements are correct? (Choose two.)

9. Site 1 contains 20+ VMs. The link between Site 1 and Leaf1 goes down.

Referring to the exhibit, which statement is correct?

10. Referring to the exhibit.

What happens when you initiate ZTP on a QFX5120 switch running Junos 21.3R1.9?

11. Referring to the exhibit.

You have a data center in which only the spine devices are using EVPN and VXLAN. The leaf nodes are multihomed in active-active mode to the spine nodes through ESI LAG interfaces. In this design, a link failure on the interface connecting the spine nodes would also cause all traffic from the spine to the leaf nodes to drop.

In this scenario, which command configured on which nodes would solve this problem?

12. You are evaluating which method to use for learning MAC addresses in your VXLAN network.

Which statement is true in this scenario?

13. Referring to the exhibit, which two statements are correct? (Choose two.)

14. You are asked to implement a monitoring and telemetry solution for the QFX Series devices in

your IP fabric that uses a push model to collect both system event data and statistical data for your QFX Series devices.

Which technology satisfies your requirements?

15. You are configuring an MX Series router to act as a Layer 3 gateway to route traffic between VXLANs in different data centers across a WAN connection.

In this scenario, what must you do to enable this communication?

16. You are deploying a switch using ZTP.

Which two statements are true in this scenario? (Choose two.)

17. You are asked to build a single export policy that can be applied to all devices to advertise only loopback IP addresses in the 172.16.0.0/24 subnet into your EBGP IP fabric.

In this scenario, which two solutions would accomplish this task? (Choose two.)

18. When considering VRF routing-instances for network segmentation, which two statements are true? (Choose two.)

19. What are two types of EVPN routes? (Choose two.)

20. You are considering deploying a MAC-VRF type routing instance with a VLAN-bundle service type. In this scenario, which two statements are correct? (Choose two.)

21. Referring to the exhibit, you have a data center with two PODs. Seamless EVPN-VXLAN stitching is used to facilitate communication between the PODs.

Which three statements are true in this scenario? (Choose three.)

22. A customer wants to connect two data centers on different subnets using EVPN.

What are two implications of using different IP subnets at each site? (Choose two.)

23. You want to enable an EBGP-based IP fabric to allow ECMP routes to be populated into the RIB.

In this scenario, which action will accomplish this task?

24. Which two statements are true about VRF routing instances? (Choose two.)

25. Referring to the exhibit, you want to advertise the IRB routes between both routing instances.

Which two configuration parameters would be applied to accomplish this task? (Choose two.)

26. You have deployed a multitenant EVPN-VXLAN fabric. You must have the routes in the BLUE VRF show up in the RED VRF.

In this scenario, how would you achieve this goal?

27. You are building an IP fabric underlay for your data center. You are asked to ensure that the two spine devices are in the same AS (65000) while the six leaf devices are in a different AS (65512).

In this scenario, which two statements are correct by default? (Choose two.)

28. Which two statements about ZTP are true? (Choose two.)

29. You are deploying a 3-stage Clos IP fabric in your data center. In this scenario, which statement is correct?

30. You are deploying an EBGP IP fabric. In this scenario, which statement is true?

31. You are asked to scale the available bandwidth within your Clos data center network to support more east-west traffic.

In this scenario, what are two ways to accomplish this task? (Choose two.)

32. Which two statements are correct about a spine and leaf-based IP fabric? (Choose two.)

33. You are troubleshooting a traditional Clos Layer 3 IP fabric in your data center.

You are reviewing the BGP configuration for one of your spine devices.

Referring to the exhibit, which statement is correct?

34. Referring to the exhibit, which statement is correct?

35. You are asked to deploy an Ethernet bridging design in a data center with the criteria shown below.

- Routing must occur on the spine devices.

- VTEPs must terminate on the leaf devices.

- Facilitate inter-VLAN communication.

- Layer 2 gateways must be present on spine and leaf devices.

Which architecture should you use in this scenario?

36. The two data centers shown in the exhibit need to be connected using EVPN.

Which two statements are correct in this situation? (Choose two.)

37. What is an advantage that EVPN has over VPLS when used for DCI?

38. You are asked to enable visibility into your EVPN-VXLAN network traffic by monitoring traffic continuously.

Which two statements are correct in this scenario? (Choose two.)

39. You are troubleshooting a problem with traffic not reaching a remote VTEP.

Referring to the exhibit, what is the reason for the problem?

40. The configuration shown in the exhibit is intended to set up assisted replication but will not commit.

Which action will create a valid configuration in this situation?

41. You are configuring a DCI VPN solution between sites that require an L3VPN to work with your EVPN deployment. Your organization's policy restricts configuring RSVP and LDP on your WAN links. While configuring the solution, you notice that no routes exist in the inet table.

In this scenario, which parameter will solve this problem?

42. You are asked to configure JTI on the QFX Series devices in your data center fabric. You must use sensors with the least amount of latency.

Which type of sensor should you use in this scenario?

43. You are asked to manage multicast traffic in the EVPN-VXLAN environment. You must ensure that multicast traffic is delivered only to the leaf device with interested receivers.

In this scenario, which feature is required on leaf devices to accomplish this task?

44. An EVPN-signaled VXLAN overlay has been deployed in the network shown in the exhibit. An EVPN LAG has been configured to connect host1 to the network, and device leaf1 has been elected as the designated forwarder.

In this scenario, which statement is true?

45. Which statement is true about the route shown in the exhibit?

46. You are asked to implement VXLAN in your data center network. You must choose between implementing EVPN signaling and multicast signaling.

Which two statements are correct in this scenario? (Choose two.)

47. You have a two spine and four leaf CRB topology and you must ensure that the hosts connected to the leaf devices have reachability to all IRB interface addresses, including the local spine IRB addresses, and the virtual gateway address.

Which two configuration parameters must be used to accomplish this task? (Choose two.)

48. You are troubleshooting a connectivity issue across a VXLAN overlay network. In the exhibit, you are using the ping overlay command from a local VTEP residing on a OFX 5120 to a remote VTEP residing on a separate QFX5120.

What is the problem in this situation?

49. Which event triggers the generation of a EVPN type-4 route?

50. A VXLAN has been created between devices leaf1 and Ieaf3.

Referring to the exhibit, which statement is true?

51. You choose the EBGP design shown in the exhibit as your IP fabric design.

You must ensure that both routes received by the spine nodes will be used for ECMP forwarding.

Which BGP parameter would need to be added to the EBGP configuration of the spine nodes to achieve this goal?

52. Referring to the exhibit, you must advertise the Io0.12 interface as a type-5 route.

Which configuration parameter would be used to accomplish this task?

53. Which two statements about the seamless EVPN-VXLAN stitching interconnect gateways are correct? (Choose two.)

54. Referring to the exhibit, which statement is correct?

55. Referring to the exhibit,

What effect does EVPN core isolation have?