300-510 Free Dumps (Part 2, Q41-Q80) Are Online – Read to Check the Quality of the 300-510 Dumps (V14.02)

1. Refer to the exhibit.

Router 1 has attempted to establish a Cisco MPLS TE tunnel to router 2, but the tunnel has failed.

Which statement about this configuration is true?

2. Refer to the exhibit

Which router does R1 install as an alternate next hop when trying to reach R3 if LFA is enabled?

3. Refer to the exhibit.

Routers R1 and R2 cannot form a neighbor relationship, but the network is otherwise configured correctly and operating normally.

Which two statements describe the problem? (Choose two.)

4. Refer to the exhibit.

P1 and PE3 Cisco IOS XR routers are directly connected and have this configuration applied. The BGP session is not coming up. Assume that there is no IP reachability problem and both routers can open tcp port 179 to each other.

Which two actions fix the issue? (Choose two.)

5. Which command is used to enable BIDIR-PIM under global configuration mode for Cisco IOS XE Sofware?

6. Which output from the show isis interface command helps an engineer troubleshoot an IS-IS adjacency problem on a Cisco IOS-XR platform?

7. A network engineer is troubleshooting OSPF multiare A.

Which Cisco IOS XR feature should the engineer use in order to streamline OSPF issue?

8. Refer to the exhibit.

After troubleshooting BGP traffic steering issue, which action did the network operator take to achieve the correct effect of this configuration?

9. For which reason can two BGP peers fail to establish a neighbor relationship?

10. In a PIM-SM environment, which mechanism determines the traffic that a receiver receives?

11. Which statement about BFD on Cisco IOS XR Software is true?

12. Which two routing protocols have extensions capable of running SRv6? (Choose two.)

13. DRAG DROP

Drag and drop the attributes for the BGP route selection on the left into the correct order on the right. Not all options are used.

14. Refer to the exhibit.

A network engineer implemented this segment routing configuration.

Which statement about the output is true?

15. Refer to the exhibit.

CE1 is the gateway router into the provider network via PE1. A network operator must inject a default route into OSPF area 0. All devices inside area 0 must be able to reach PE1.

Which configuration achieves this goal?

A)

B)

C)

D)

16. Which two characteristics unique to SSM when compared to ASM are true? (Choose two.)

17. Refer to the exhibit.

P1 and PE3 Cisco IOS XR routers are directly connected and have this configuration applied. The BGP session is not coming up. Assume that there is no IP reachability problem and both routers can open tcp port 179 to each other.

Which action fixes the issue?

18. Refer to the exhibit.

An engineer has successfully fixed BGP peering issue. R1 has an established eBGP peering with R2 and R3.

Which mechanism should the engineer apply in order to steer the traffic correctly?

19. Refer to the exhibit.

Which attribute can router 1 alter so that only other iBGP peers prefer to use 192.168.4.2 as the next hop for route 192.168.3.0/24?

20. Refer to the exhibit.

A network operator must stop 10.33.33.33/32 from being redistributed into Level 1 router XR1.

Which configuration meets this need?

A)

B)

C)

D)

21. Refer to the exhibits.

All links inside the network are configured at a default cost of one inside the fully converged OSPF domain.

Given the configuration from XR1, which interface does traffic from XR1 that is destined to the loopback interface of XR6 select for the exiting interface?

22. After an engineer configures BGP in R1, it starts receiving this message

*Jun 29 13:30:50.122: %BGP-5-ADJCHANGE: neighbor 192.168.10.1 Down User reset

Jun 29 13:30:52.341: %BGP-3-NOTIFICATION: sent to neighbor 192.168.10.1 2/6 (unacceptable hold time) 0 bytes

Which action makes the peering come back up again?

23. Refer to the exhibits.

A network operator is troubleshooting packet loss seen from the R1 loopback interface to the R2 loopback interface over the core network. The operator is attempting to identify the next leg in the path from PE1.

Which interface and label path should the operator investigate next?

24. Refer to the exhibit.

Routers R1, R2. R3, and R4 have been configured to run OSPF. and router R5 is running EIGRP Traffic from R1 to R5 is expected to pass via R4. but OSPF routing has calculated the best path via R3.

Which action corrects the problem?

25. Refer to the exhibit.

A network operator is troubleshooting TE tunnels and discovers that the soft preemption is not working as desired.

Where should the soft preemption be applied to solve the issue?

26. Refer to the exhibit.

What is the relationship between Router 1 and Router 2?

27. Which command is used to enable BIDIR-PIM under global configuration mode for Cisco IOS XE Software?

28. What is the purpose of a BGP confederation?

29. What is the characteristic of enabling segment routing for IGPs?

30. Refer to the exhibit.

While configuring router 2 with all the default values, a network engineer cannot see any route received in router 1.

How should the engineer solve the issue?

31. Refer to the exhibit.

An engineer has configured all routers in the environment to run IS-IS Level 1 and Level 2 routing.

The engineer wants traffic from R1 to R5 to pass via R2. but IS-IS routing has calculated the best path via R4.

Which action corrects the problem?

32. What are three requirements for a static IPv6-in-IPv4 tunnel? (Choose three.)

33. Which expression, when used with the as-path-set command, matches the AS path attribute of the route?

34. What are two differences between OSPF and IS-IS? (Choose two.)

35. A network engineer is troubleshooting OSPF multiarea.

Which Cisco IOS XR feature should the engineer use in order to streamline OSPF issue?

36. Refer to the exhibit.

Routers within the cluster are not receiving the desired prefixes.

What must be done to fix the issue?

37. Refer to the exhibit.

A network operator is working to deploy a Unified BGP design and allow it to be available only in selected markets and services in the future. The label allocation is not functioning as desired.

Which action will fix the issue?

38. An engineer is working to implement segment routing protocol on the customer's core network.

Which step should the engineer take before the segment routing is enabled and is running with BGP?

39. After changing the IP address on an IOS XR router, an engineer cannot ping the new address.

Which step did the engineer forget to complete?

40. Refer to the exhibit.

The green policy is designed with low delay, and the pink policy is designed with low cost.

What is the next hop for node A on its way to node D, with the objective of achieving a low delay?