Pass Associate – Networking Exam DEA-5TT2 Exam: Updated DEA-5TT2 Dumps V9.03 Ensure Your Success

1. In which Spanning Tree protocol state does a port record MAC addresses but does not forward the data?

2. Which port type should be used for only VLAN-unaware devices?

3. Which Ethernet frame forwarding method works best when the outbound ports run at the same speed as the inbound port?

4. Which port type does a Dell EMC Networking N-Series switch have for its console connection?

5. Which type of domains are connected by a Layer 2 switch?

6. Which component translates data, signaling, and protocols to facilitate the data flow between the end device and the network?

7. A network administrator created three VLANs on an Ethernet switch.

How many broadcast domains are created by the switch?

8. Which fields are mandatory TLVs in a LLDP PDU frame?

9. When configuring a switch, which CLI mode only supports limited show commands?

10. On which Dell EMC Networking switches can Multi-Chassis Link Aggregation (MLAG) be configured?

11. On which OSI layers do standard ACL filters operate?

12. What is the Organizationally Unique Identifier (OUI) in the MAC address 00:C4:4F:23:AF:4A?

13. What are Network Address Translation (NAT) inside global addresses?

14. Which BASE-T Ethernet standard specifies a CAT6 cable type?

15. Which Dell EMC Networking M-Series 10 GbE switch model supports a VLT?

16. DRAG DROP

The IEEE separates the Data Link and Physical ISO layers into four sub-layers.

Based on the exhibit, what is the correct order of these sub-layers; from lowest to highest?

17. If a packet is sent to an IPv6 address and many devices receive the packet, what is this type of traffic?

18. You recently joined a company as a junior-level network administrator. You have been tasked with designing the IPv4 scheme for five networks that will be used for training classrooms. These networks need to support no more than 28 devices each. Due to the existing network design, the senior-level network administrator has asked you to work on network 192.168.40.0/24.

If all networks must be made to logically start with the lowest numbered network and end with the largest numbered network, what is the network ID for the third network?

19. Which IPv6 scope is used for private addressing on a local network?

20. What is the default OSPF “hello interval”?