Nokia Multicast Protocols 4A0-108 Dumps Questions

4A0-108 Nokia Multicast Protocols, the former name is Alcatel-Lucent Multicast Protocols, is for Nokia Service Routing Architect certification. DumpsBase is one of the best source to provide 4A0-108 dumps questions. With real 4A0-108 exam questions and answers, you can be rest assured that you will pass your Nokia 4A0-108 exam on Your First Try. It will also save your valuable time.

DumpsBase 4A0-108 Dumps Help you pass easily, Demo Can be Tested Online

1. What is the destination address for MLDv2 report?

2. In IPv6 multicast ASM mode, which of the following methods cannot be used to obtain the RP address?

3. The network administrator of 2001:DB8:FEED::/64 wants to embed an RP for the network and the RP's address is 2001 :DB8:FEED::7.

Which of the following multicast address ranges would suit this purpose? (The exhibit of Group-to-RP Mapping is just for your reference)

4. Which of the following ranges is reserved for IPv6 SSM multicast address?

5. Refer to the exhibit.

According to the PIM configuration on SR-3, can the receiver in the diagram receive multicast traffic from the source for group FF70:340:2001::1000? Assume all the other configurations are correct.

6. Which of the following multicast packets can be forwarded on the Internet?

7. What is the destination address for MLDv2 general query?

8. IGMP version 3 Host Membership Queries are sent with a TTL of 1 to which of the following addresses?

9. How does IGMP snooping eliminate multicast flooding on the LAN?

10. Refer to the configuration exhibit.

What will happen when this router receives an IGMPv3 exclude none report for group 232.1.1.1?

11. Refer to the following exhibit.

Assuming all links have an equal metric in the IGP, where will the Shared Path Tree be built when Receiver 3 joins the multicast group?

12. Refer to the following exhibit.

Assuming all links have an equal metric in the IGP, where will Source Path Tree have been created if Receiver 2 and Receiver 3 have joined the multicast group and the source is sending and the switchover has occurred? (Choose two)

13. What is the function of the MDT?

14. What impact will an asymmetric IGP routing topology have on the PIM RPF check?

15. How many multicast groups may a single receiver join at any one time?

16. Where is the best placement of the Rendezvous Point in a PIM SSM network?

17. Refer to the following configuration exhibit.

How many interfaces have receivers joining group 239.1.1.1?

18. Which of the following commands will verify the PIM DR on an interface on the Alcatel-Lucent 7750 SR?

19. Refer to the following exhibit.

The interfaces' IGP metric is as shown and PIM is using unicast table for RPF-check.

What will happen when Router B receives the register message on its interface facing Router A?

20. Which of the following configuration steps are mandatory for IPv4 PIM ASM to work? (Choose two)


 

Nokia Scalable IP Networks 4A0-100 Dumps
Alcatel-Lucent Triple Play Services 4A0-109 Exam Questions

Add a Comment

Your email address will not be published. Required fields are marked *