100-490 Dumps Updated – 100-490 RSTECH Dumps (V10.02) Will Improve Your Exam Preparation

1. Which protocol does TFTP typically use for transport?

2. What is the correct IPv6 address notation?

3. Which two statements about Telnet and SSH are true? (Choose two.)

A. SSH is a protocol that provides a secure remote access connection to network devices.

B. SSH uses the well-known TCP port 23 for its communication.

C. A Telnet network management connection is dropped when a router reboots.

D. Telnet is a protocol that provides a secure remote access connection to network devices.

E. Telnet is preferred over SSH for security reasons.

4. Which address facilitates the routing of packets over an IP network?

5. Which two IPv4 addresses can be assigned to a host computer? (Choose two.)

A. 255.255.255.255

B. 10.1.1.20

C. 0.0.0.0

D. 192.168.10.15

E. 292.10.3.4

6. What are two components of a WAN connection? (Choose two.)

7. Which device is a DTE device?

8. Which layer of the OSI model defines how data is formatted for transmission and how access to the physical media is controlled?

9. Which command shows the status of power supplies and sensor temperatures?

10. What are two standard fiber-optic connectors? (Choose two.)

11. Which type of physical connector does a Gigabit Ethernet port typically use?

12. Which two pairs of LAN Ethernet devices use an RJ-45 straight-through cable? (Choose two.)

13. Which two features are associated with single-mode fiber-optic cable? (Choose two.)

14. Refer to the exhibit.

Which two statements about the hardware components are true? (Choose two.)

15. Which type of transceiver module is used for 40 Gigabit Ethernet connectivity?

16. What is the line speed of a DS0 in North America?

17. Which two ports on a laptop are used to gain console access to a Cisco switch? (Choose two.)

18. Which two statements about a SmartJack are true? (Choose two.)

19. The colored wires at one end of a cable are in reverse sequence to the colored wires at the other end of the cable.

Which cable does this configuration describe?

20. Which Cisco CPAK 100GBASE module supports Multimode Fiber cable?